← TEKTELIC at INNON® / COMFORT Moisture Rope — Plastic

A Ready For Anything® accessory

A plastic-covered moisture detection rope for the COMFORT V2 — USB-C, 3m. For plant rooms, industrial spaces, and anywhere the fabric version would not survive the environment.

USB-C connection · 3m rope · Plastic cover · Linear leak detection · Works with COMFORT V2

What this accessory does on site

Same linear detection capability as the fabric rope — water contact anywhere along the 3m length triggers a leak event in the COMFORT V2 uplink — with a harder-wearing plastic cover suited to plant rooms, boiler rooms, and industrial environments where the rope is exposed to grit, grease, or mechanical contact.

Run it under raised flooring in a plant room, around the base of a water tank, or beneath plant equipment where a slow leak would otherwise go undetected until it caused damage. The COMFORT V2 maps the event to a BACnet binary value in Niagara.

Compatibility

• Requires TEKTELIC COMFORT V2 sensor body
• USB-C connection — plug and play, no configuration required
• Moisture event reported as a discrete property in the COMFORT V2 uplink payload
• BACnet object mapping via KONA gateway embedded LNS

Why this accessory is Ready For Anything®

🟢 Ready for Today

• 3m of linear leak detection built for tough environments — plastic cover resists grit, grease, and mechanical contact in plant rooms, boiler rooms, and industrial spaces where fabric rope would degrade
• Water contact anywhere along the rope triggers a BACnet event — one COMFORT V2, one LoRaWAN slot, 3m of coverage; map to a Niagara alarm like any wired leak detector
• Catches slow leaks before they become failures — laid under plant equipment or along a pipe run, the rope detects early moisture before it becomes a visible problem

🔵 Ready for Change

• Extends COMFORT V2 without hardware swap — plug in and moisture reporting starts; no new device, no gateway slot consumed, no Niagara reconfiguration
• Harder wearing than fabric for plant room use — designed to survive the environment where leak detection matters most

🔗 Ready for Integrations

• Works within the existing TEKTELIC stack — COMFORT V2 plus KONA gateway plus Niagara; moisture property appears automatically in the existing BACnet device object

Requires TEKTELIC COMFORT V2 sensor body. For office environments consider the fabric cover rope instead. Contact [email protected].